Bearing sleeve stopper
For the small bearing installed on the step shaft of the Bearing fixed sleeve, a hammer can be used to knock the small end face of the lock nut of the fixed sleeve through a special sleeve to remove it. Before that, loosen the set lock nut for several turns.
For the bearing installed on the fixed sleeve matching stepped shaft, the use of hydraulic nut can make the bearing disassembly easier. For this purpose, install a suitable stop device close to the piston of the hydraulic nut. The oil injection method is a simpler method, but the tightening sleeve with oil hole and oil groove is used.
Remove the bearing on the disassembly sleeve
When removing the bearing on the disassembly sleeve, it is necessary to remove the locking device. (such as lock nut, end plate, etc.)
For small and medium-sized bearings, lock nuts, hook wrenches or impact Bearing wrenches can be used for disassembly.
